SW12USB


============= System Information Commands
?/HELP        Print Help Information
STATUS        Print System Status And Port Status
============= System Control Commands
PON/OFF       Set System Power On Or Off
RESET         Reset System To Default Setting
               Type 'Yes' To Confirm, 'No' To Discard Within 30 Seconds
HOST yy FR All    Set Connect From Host:yy
                  yy = 01 : Host1
                  yy = 02 : Host2
SWITCH aa     Set Switching To aa
              aa = AUTO: Auto Switching ON - Auto Mode
              aa = MAN: Auto Switching OFF - Manual Mode
USBDP aa      Set USB Device Power Mode
              aa = FH : Follow Host
              aa = ON : Always On
USBDPOUT yy ON/OFF   Set USB Device Power Output
                     yy = 00 : All Devices
                     yy = 01 : Device1
                     yy = 02 : Device2
                     yy = 03 : Device3
                     yy = 04 : Device4
GPI ENABLE/DISABLE   Set GPI Mode Enable Or Disable
GPI yy        Set GPI Mode
              yy = 00 : Pulse Mode
              yy = 01 : Level Mode
              yy = 02 : Contact Closure Mode
GPI LOW xx    Set The Low Level Voltage In The Level Mode
                xx Range 0~12000  Unit mV
GPI HIGH xx   Set The High Level Voltage In The Level Mode
                xx Range 0~12000  Unit mV
KEY ON/OFF    Set Key Control On Or Off
NAME zz       Set Device Name
                zz Is New Device Name
UG HUB yy     Select Hub Upgrade
               Note: All Connected Devices Will Lost. Switch The Host Or Reconnect The USB Cable It Will Be Returned To Normal
              yy = 01 : Hub1
              yy = 02 : Hub2
SPEED yy      Set Type-A Port Speed
              yy = 00 : Speed 5Gbps
              yy = 01 : Speed 10Gbps
============= RS232 Control Commands
RS232BAUD z   Set RS232 Baud Rate To xx
              z = 1 2400, 2 4800, 3 9600, 4 19200, 5 38400, 6 57600 (Default), 7 115200
RS232ONOUT y:z:a   Send y Type Of Command a Stored In Local RS232 Whose Baud Rate Is z
              y = a ASCII, h HEX
              z = 1 2400, 2 4800, 3 9600, 4 19200, 5 38400, 6 57600 (Default), 7 115200
              a = RS232 Command
============= Network Control Commands
NET DHCP ON/OFF         Set Auto IP(DHCP) On Or Off
NET TN 8000 ON/OFF      Set Telnet Port 8000 On Or Off
NET TN ON/OFF           Set Telnet Port On Or Off
NET MDNS ON/OFF         Set mDNS On Or Off
NET IP xxx.xxx.xxx.xxx  Set IP Address
NET GW xxx.xxx.xxx.xxx  Set Gateway Address
NET SM xxx.xxx.xxx.xxx  Set Subnet Mask Address
NET RB                  Set Network Reboot And Apply New Config!!!
NET TN xxxx             Set Telnet Port